Thursday, January 27, 2011

Tuesday, January 25, 2011

rack fixture

finally took some pictures of the "completed" project. i say "completed" bc i will inevitably make changes and modifications as i see fit. but for now it does what i intended it to!

all the materials i used i had laying around. i will probably replace the square steel tubing with square aluminum stock at some point.... or not i dunno.


i can move the base in half inch increments, if i need it somewhere in the middle i can move the backstop. the line scribed on top of the base is the centerline of the dummy axle to make for easy setup. the whole concept of this rack was based around the dimensions from this post:

just a quick tack weld on the legs then the fixtures job is done.

set at 14.5", but if i nibble off a little too much mitering the legs i can slide it down, or if i need a rack height somewhere in the middle.





Monday, January 17, 2011

drilling holes


IMG_6192, originally uploaded by rackntroll.

lots of holes drilled

Sunday, January 9, 2011

Getting back to work

my rack fixture is almost complete.